Start a new topic
Solved

DVR causing goggles to freeze (1.2.1)

Not sure if this is a 1.2.0 or 1.2.1 problem as I don't think I used the dvr in the short time I was on 1.2.0. When I start the dvr recording, all controls on the goggles become unresponsive. This includes stopping the recording, going into any of the menus, powering off the goggles. They continue to function, I can change channels on the rapidfire (if I use the controls on the module) and the video feed continues to work. I have to pull the battery plug.


4 people have this problem

Just tested this and I can reproduce it on low and high end SD cards. 

That is a U1 rated card with a guaranteed transfer rate of 10MB/s. Looks like a higher rate may be required. U3 class are rated for 30MB/s. 


ORQA Team, can we please get an official spec for required card speeds? Thanks.

I have a SanDisk Ultra 32GB A1 U1 card that does not work in the googles. If I hit record it starts but I am unable to stop recording. I have to pull the battery plug to get back to using the googles. Of course I have formatted the card in googles. 


The SanDisk Extreme 128GB A2 U3 card I have works without issue. I am able to stop recording as expected and then control the googles again. 


I cannot find a stated minimum speed rating for the SD card to work with the FPV.One in the manual or elsewhere. Has this been tested or is there an official standard? 

I got my gogles with fw version 1.1.5. And I had the same issue. Upgraded fw to 1.2.1 and I still have the same problem. The only way to stop recording is to pull out battery.

Well, that is unfortunate (:

For mine, it appears it's going to happen every time. I was testing some mics I had to see if they worked with the goggles so I started the dvr several times and because they froze, had to power cycle them between each attempt.

Hm, let's see how much come across that issue. I didn't use the goggle since the two tries mentioned above, but if this issue happens everytime you start DVR, I might prefer downgrading, because I noticed that the second DVR was not saved.

I did a factory reset on mine.

I did use the DVR while on 1.2.0 and it seems that the issue did come with 1.2.1 - at least I didn't come across the issue there and I did use the goggle a lot more than while 1.2.1 (for obvious reasons). I booted the goggle two times today (since I updated the firmware) and started DVR each time. In both cases the goggle froze.


DVR wise it does seem like the DVR start/stop button does still work - but you will neither hear a sound nor will the other buttons lead to any UI action (no menu does open). I'm using TBS Fusion - therefore I can't say anything about the RapidFire. Interestingly reception seemed worse than two days ago with 1.2.0 in the same spot with the same quad and analog setup.


I didn't make a factory reset - maybe one should give that a shot.

Login or Signup to post a comment