1. Open the second bay (where the QR code is)
2. Take the ribbon cable and the FPV.Connect
3. Open the connector lever on the FPV.Connect and put the ribbon cable inside. Check if you have pushed it right.
4. Close the drawer and close the bay.
Note: The grey side of the ribbon cable needs to be upside when putting it into the connector
How to install FPV.Connect to the goggles? Print
Created by: Orqa FPV Support
Modified on: Tue, 9 Jun, 2020 at 1:16 PM
Did you find it helpful? Yes No
Send feedbackSorry we couldn't be helpful. Help us improve this article with your feedback.